Pharmaline N and X hose can be supplied loose, or as custom built hose assemblies after the hose size and grade, length and end fittings have been selected.
The specification and information contained in this brochure can be used to make these selections, but if there are any doubts concerning the hose usage limitations or performance capabilities, customers should request expert advice from Aflex Hose.
There are two types of PTFE hose liner tube available, natural PTFE (Pharmaline N or X, GP grade), and antistatic PTFE (Pharmaline N or X, AS grade).
The lengths of Pharmaline N and X hose assemblies are as specified by the customer and the length is measured from the sealing face at one end fitting to the same at the other end of the hose. Length tolerances are normally +2% / -0%.
Minimum hose assembly lengths are calculated by adding the lengths of the hose end fittings, the A dimensions, then adding the minimum ‘visible’ length of hose between the fittings as per the table below.
If the hose must be flexed, however, then there must be a sufficient length of visible hose to conform to the required flexing configuration (see Hose Usage Limitations).
† Maximum hose assembly lengths are as per the table below.
Lengths may be stated in Feet & Inches, or decimal Metres or Millimetres. Units used must be stated.
Pharmaline N&X are available with a range of standard end fittings.
Non-Lined Spigots - are all made from Grade 316L SS = EN 1.4404
Cam & Groove Female Fittings - are made from Grade 316C SS = EN 1.4408 (Body) and 316L SS (Spigot)
Swivelling Nuts and Flanges- are all made from Grade 304 SS = EN 1.4301
Ferrules - most ferrules are made from Grade 304 SS, otherwise Grade 316 SS
|Nominal Size of Hose||Minimum Visible Hose Length |
|† Pharmaline N Maximum |
Hose Assembly Length
|Pharmaline X Maximum |
Hose Assembly Length
|Used Straight||Flexed Through 90°|
†Longer lengths may be available to special order - Consult Aflex Hose for details.
The quantity, hose type, size, grade, length and fittings must be specified in full.
Either by a full, written description. The hose grade can be specified by the code initials e.g. “Pharmaline N, AS” defines an antistatic PTFE lined Pharmaline N hose.
The quantity, length and fittings can then be written in - e.g. “4 off x 1” bore Pharmaline N, AS hoses x 3.00 metres long. Both ends ANSI 150# S/S Flanges”.
OrbyPart Numbers. Any special requirements relating to the hose construction, or information required on Tags, or Certificates, or special testing requirements, must be specified in full on the enquiry or purchase order.
Pharmaline N and X hose and hose assemblies are only supplied on the basis that the customer has read and accepted the Conditions of Sale.